I purchased this module as part of a microcontroller kit, its an interesting little module as it has 16 buttons but with only 1 I/O line is required, an analog input. …

In this example we will take the previous bmp180 example – Nucleo and BMP180 example. This time again we will connect an LCD Keypad shield and display the temperature and pressure …

In this example we will connect a BMP180 sensor to our Nucleo board. Typically this is in some sort of breakout or module such as the one below   Description …

In this example we take our Nucleo and AM2303 sensor example and we add an LCD Keypad shield and display the temperature and humidity on this. Here is  a picture of that …

AM2302 capacitive humidity sensing digital temperature and humidity module is one that contains the compound has been calibrated digital signal output of the temperature and humidity sensors. Application of a …

In this example we will create a simple flashing led example for the MINI STM32 board, I used this to test out a J-link from segger and also to try …

Being a sucker for a bargain and wanting to get into basic ARM development I’ve bought a couple of STM32 boards in the past, these tend to be low cost …

In this example we will connect an LCD keypad shield commonly used on Arduino projects and then connect an ultrasonic sensor to this shield. The ultrasonic sensor used is the …

HC-SR04 is an ultrasonic ranging module that provides 2 cm to 400 cm non-contact measurement function. The ranging accuracy can reach to 3mm and effectual angle is < 15°. It …

This was an RGB Led breakout example connected to our mbed LPC1768 board, we used a common anode type. here is a picture of the module, you could of course use …

In this example we connect an LCD to our mbed LPC1768 and display some text on it, we use a library to do most of the hard work here so …

The mbed LPC1768 is based on the NXP LPC1768, with a 32-bit ARM Cortex-M3 core running at 96MHz. It includes 512KB FLASH, 32KB RAM and lots of interfaces including built-in …