MBed

STM32 Nucleo and TSL2561 Luminosity Sensor example

This TSL2561 is an I2C light-to-digital converter TSL2561 that transforms light intensity to a digital signal. The TSL2561 features a selectable light spectrum range due to its dual light sensitive diodes: infrared and full spectrum. You can switch among three detection modes to take your...

STM32 Nucleo and LM75 temperature sensor example

In this example we connect an LM75 to a STM32 Nucleo and we will use the MBEd compiler The LM75 temperature sensor includes a delta-sigma analog-to-digital converter, and a digital overtemperature.

STM32 Nucleo and MS5611 barometric pressure sensor example

In this example we connect an MS5611 to an STM32 Nucleo - in this case it was a Nucleo-F446RE This barometric pressure sensor is optimized for altimeters and variometers with.

STM32 Nucleo and LM35 temperature sensor

In this example we will connect an LM35 temperature sensor to our Nucleo board and we will be using the MBed compiler The LM35 series are precision integrated-circuit temperature sensors, whose output voltage is linearly proportional to the Celsius (Centigrade) temperature. The LM35 thus has...

STM32 Nucleo and ML8511 sensor example

In a previous example we showed how to connect an ML8511 to an Arduino Due, this time we are using a Nucleo board - in fact this was tested with.

ST Nucleo and MAX6675 example

In this example we take a look at the MAX6675 Cold-Junction-Compensated K-Thermocouple-to-Digital Converter and connect it to a Nucleo-F334R8 The MAX6675 performs cold-junction compensation and digitizes the signal from a type-K.

STM32 Nucleo and Easy module shield more examples

The Easy Module Shield V1 is a basic shield for the Arduino which has several useful components fitted that can be used for beginners learning, here is a list of these components A DHT11 temperature and humidity sensor An LM35 temperature sensor A piezo buzzer...

MBed and a PCF8574

The PCF8574 is an 8 bits I/O port expander that uses the I2C protocol. Using this IC, you can use only the SDA and SCL pins of your Arduino board.

LPC1768 and MLX90614 infrared thermometer

The MLX90614 is a non-contact infrared thermometer with a measurement range from -70 to +380 degree Celsius. Just connect the four leads to your MBed supported device and you will have.

MBed LPC1768 and ADXL345 GY-291 example

The ADXL345 is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16g. Digital output data is formatted as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface. The ADXL345 is...