This example shows how to connect a joystick to your St Nucleo. This could be used for games or perhaps navigating through a menu for example Here is a picture of the joystick I am using, this is commonly found for sale on many sites. Usually...
Code
I purchased this module as part of a microcontroller kit, its an interesting little module as it has 16 buttons but with only 1 I/O line is required, an analog input..
In this example we will take the previous bmp180 example - Nucleo and BMP180 example. This time again we will connect an LCD Keypad shield and display the temperature and pressure.
In this example we will connect a BMP180 sensor to our Nucleo board. Typically this is in some sort of breakout or module such as the one below Description This precision sensor from Bosch is the best low-cost sensing solution for measuring barometric pressure...
In this example we take our Nucleo and AM2303 sensor example and we add an LCD Keypad shield and display the temperature and humidity on this. Here is a picture of that.
AM2302 capacitive humidity sensing digital temperature and humidity module is one that contains the compound has been calibrated digital signal output of the temperature and humidity sensors. Application of a.
In this example we will create a simple flashing led example for the MINI STM32 board, I used this to test out a J-link from segger and also to try out the MikroC Pro for ARM IDE. Here is a picture of the board, it...
In this example we will connect an LCD keypad shield commonly used on Arduino projects and then connect an ultrasonic sensor to this shield. The ultrasonic sensor used is the.
HC-SR04 is an ultrasonic ranging module that provides 2 cm to 400 cm non-contact measurement function. The ranging accuracy can reach to 3mm and effectual angle is < 15°. It.
This was an RGB Led breakout example connected to our mbed LPC1768 board, we used a common anode type. here is a picture of the module, you could of course use an RGB led and 3 resistors instead Red...
In this example we connect an LCD to our mbed LPC1768 and display some text on it, we use a library to do most of the hard work here so.
The mbed LPC1768 is based on the NXP LPC1768, with a 32-bit ARM Cortex-M3 core running at 96MHz. It includes 512KB FLASH, 32KB RAM and lots of interfaces including built-in.